Citrix 1Y0-350인증시험이 이토록 인기가 많으니 우리ITExamDump에서는 모든 힘을 다하여 여러분이 응시에 도움을 드리겠으며 또 일년무료 업뎃서비스를 제공하며, ITExamDump 선택으로 여러분은 자신의 꿈과 더 가까워질 수 있습니다. 희망찬 내일을 위하여 ITExamDump선택은 정답입니다. ITExamDump선택함으로 당신이 바로 진정한IT인사입니다.
ITExamDump는ITExamDump의Citrix인증 1Y0-350덤프자료를 공부하면 한방에 시험패스하는것을 굳게 약속드립니다. ITExamDump의Citrix인증 1Y0-350덤프로 공부하여 시험불합격받으면 바로 덤프비용전액 환불처리해드리는 서비스를 제공해드리기에 아무런 무담없는 시험준비공부를 할수 있습니다.
Citrix인증1Y0-350시험의자격증은 여러분에 많은 도움이 되리라 믿습니다. 하시는 일에서 한층 더 업그레이드될 것이고 생활에서도 분명히 많은 도움이 될 것입니다. 자격증취득 즉 재산을 얻었죠.Citrix인증1Y0-350시험은 여러분이 it지식테스트시험입니다. ITExamDump에서는 여러분의 편리를 위하여 ITExamDump만의 최고의 최신의Citrix 1Y0-350덤프를 추천합니다. ITExamDump를 선택은 여러분이 최고의 선택입니다. ITExamDump는 제일 전면적인Citrix 1Y0-350인증시험자료의 문제와 답을 가지고 잇습니다.
시험 번호/코드: 1Y0-350
시험 이름: Citrix (Citrix NetScaler 10 Essentials and Networking)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 126 문항
업데이트: 2014-02-09
ITExamDump에는 전문적인 업계인사들이Citrix 1Y0-350시험문제와 답에 대하여 연구하여, 시험준비중인 여러분들한테 유용하고 필요한 시험가이드를 제공합니다. 만약ITExamDump의 제품을 구매하려면, 우리ITExamDump에서는 아주 디테일 한 설명과 최신버전 최고품질의자료를 즉적중율이 높은 문제와 답을제공합니다.Citrix 1Y0-350자료는 충분한 시험대비자료가 될 것입니다. 안심하시고 ITExamDump가 제공하는 상품을 사용하시고, 100%통과 율을 확신합니다.
우리ITExamDump 에서는 여러분들한테 아주 편리하고 시간 절약함과 바꿀 수 있는 좋은 대책을 마련하였습니다. ITExamDump에서는Citrix 1Y0-350인증시험관련가이드로 효과적으로Citrix 1Y0-350시험을 패스하도록 도와드리겠습니다.만약 여러분이 다른 사이트에서도 관련덤프자료를 보셨을 경우 페이지 아래를 보시면 자료출처는 당연히 ITExamDump 일 것입니다. ITExamDump의 자료만의 제일 전면적이고 또 최신 업데이트일것입니다.
ITExamDump의Citrix인증 1Y0-350덤프는 고객님의 IT인증자격증을 취득하는 소원을들어줍니다. IT업계에 금방 종사한 분은 자격증을 많이 취득하여 자신만의 가치를 업그레이드할수 있습니다. ITExamDump의Citrix인증 1Y0-350덤프는 실제 시험문제에 대비하여 연구제작된 퍼펙트한 시험전 공부자료로서 시험이 더는 어렵지 않게 느끼도록 편하게 도와드립니다.
Pass4Tes가 제공하는 제품을 사용함으로 여러분은 IT업계하이클래스와 멀지 않았습니다. Pass4Tes 가 제공하는 인증시험덤프는 여러분을Citrix인증1Y0-350시험을 안전하게 통과는 물론 관연전업지식장악에도 많은 도움이 되며 또한 우리는 일년무료 업뎃서비스를 제공합니다.
1Y0-350 덤프무료샘플다운로드하기: http://www.itexamdump.com/1Y0-350.html
NO.1 A network engineer has configured two NetScaler MPX appliances as a high availability (HA)
pair.
What can the engineer configure to prevent failover if only a single interface fails?
A. FIS
B. PBR
C. SNMP
D. VMAC
Answer: A
Citrix 1Y0-350 1Y0-350 1Y0-350
NO.2 Scenario: An engineer executes the following commands:
add vlan 2 bind vlan 2 -ifnum 1 / 2 add ns ip 10.110.4.200 255.255.255.0 bind vlan 2 -IPAddress
10.110.4.200 255.255.255.0
What type of IP address has been added to the NetScaler?
A. VIP address
B. NSIP address
C. SNIP address
D. GSLB Site IP address
Answer: C
Citrix인증 1Y0-350 1Y0-350 1Y0-350덤프 1Y0-350시험문제
NO.3 A network engineer wants to optimize a published load balanced SSL virtual server for WAN
connection with long delay, high bandwidth with minimal packet drops.
What would the network engineer use to do this type of optimization for the SSL virtual server?
A. SSL policy
B. TCP profile
C. Compression policy
D. Priority queuing policy
Answer: B
Citrix시험문제 1Y0-350기출문제 1Y0-350인증 1Y0-350
NO.4 Why would an engineer want to specify a TCP Profile for a specific service group?
A. To enable use of features like SSL over TCP for that specific service group.
B. To adjust the TCP settings for traffic to and from that specific service group.
C. To use a specific SNIP for traffic to the back-end servers in that service group.
D. To enable features like use source IP , TCP keep alive and TCP buffering for a specific service group.
Answer: B
Citrix최신덤프 1Y0-350 dumps 1Y0-350
NO.5 Scenario: A NetScaler engineer needs to enable access to some web servers running on an
IPv6-only network. The clients connecting the services are on an IPv4 network. The engineer has
already enabled IPv6 on the NetScaler.
What does the engineer need to do in order to provide access to the services on the IPv6 network?
A. Create an IPv6 tunnel and a IPv4 virtual server.
B. Configure an IPv6 VLAN and bind the required interface.
C. Create a IPv4 virtual server and bind the service group to it.
D. Create an IPv6 ACL and a IPv4 virtual server and bind the ACL to the virtual server.
Answer: C
Citrix최신덤프 1Y0-350인증 1Y0-350 1Y0-350
NO.6 Scenario: A NetScaler appliance currently has a manually configured channel containing four
interfaces; however, the engineer has been told that the NetScaler must now only use a single
interface for this network. The engineer removes the channel and immediately notices a decrease in
network performance.
How could the engineer resolve this issue?
A. Reset the unused interfaces
B. Disable the unused interfaces
C. Enable flow control on all interfaces
D. Disable HA monitoring on the three interfaces that are no longer required
Answer: B
Citrix 1Y0-350최신덤프 1Y0-350인증
NO.7 Scenario: The NetScaler is connected to two subnets. The NSIP is 10.2.9.12. The external SNIP
is 10.2.7.3. The MIP for internal access is 10.2.9.3. Web servers, authentication servers and time
servers are on the 10.2.10.0/ 24 network which is available through the
10.2.9.1 router. The external firewall has the 10.2.7.1 address. Traffic bound for Internet clients
should flow through the external firewall.
Which command should be used to set the default route?
A. add route 0.0.0.0 0.0.0.0 10.2.7.1
B. add route 0.0.0.0 0.0.0.0 10.2.9.1
C. add route 10.0.0.0 255.0.0.0 10.2.9.1
D. add route 10.0.0.0 255.0.0.0 10.2.7.1
Answer: A
Citrix dumps 1Y0-350 1Y0-350덤프 1Y0-350덤프 1Y0-350
NO.8 Scenario: For security reasons, the NSIP needs to be configured to only be accessible on
interface 0/1, which is VLAN 300.
The NSIP address is 10.110.4.254 and the subnet mask is 255.255.255.0.
How would the network engineer achieve this configuration?
A. set ns config -nsvlan 300 -ifnum 0/1
B. set ns ip 10.110.4.254 -gui ENABLED -vrID 300
C. add vlan 300 set ns ip 10.110.4.254 -mgmtAccess ENABLED
D. set ns config -IPAddress 10.110.4.254 -netmask 255.255.255.0
Answer: A
Citrix덤프 1Y0-350 1Y0-350
NO.9 Scenario: A network engineer created an IPv6 virtual server on the NetScaler. The virtual
server is using a service group with two IPv4 servers bound to it. When testing access to the virtual
server from a client configured with an IPv6 address, he is unable to connect.
What could be the reason for this issue?
A. The NetScaler is disabled for NAT.
B. IPv6 protocol translation is disabled.
C. An IPv6 address on the NetScaler is not bound to the correct VLAN.
D. The NetScaler does not have an INAT rule to convert IPv4 to IPv6 from the back-end servers.
Answer: B
Citrix 1Y0-350시험문제 1Y0-350기출문제 1Y0-350
NO.10 Scenario: The NetScaler has connections to a large number of VPNs. The network engineer
wants to minimize the number of ARP requests.
Which feature should the network engineer enable to minimize ARP requests?
A. TCP Buffering
B. Use Source IP
C. Edge Configuration
D. MAC based forwarding
Answer: D
Citrix 1Y0-350시험문제 1Y0-350시험문제 1Y0-350 1Y0-350인증
ITexamdump의 000-587덤프의 VCE테스트프로그램과 70-247덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 CTAL-TM_Syll2012시험에 대비한 고품질 덤프와 HP0-J62시험 최신버전덤프를 제공해드립니다. 최고품질 JK0-U31시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기