ITExamDump의Motorola Solutions인증 MSC-122덤프의 인지도는 아주 높습니다. 인지도 높은 원인은Motorola Solutions인증 MSC-122덤프의 시험적중율이 높고 가격이 친근하고 구매후 서비스가 끝내주기 때문입니다. ITExamDump의Motorola Solutions인증 MSC-122덤프로Motorola Solutions인증 MSC-122시험에 도전해보세요.
ITExamDump 에서는 최선을 다해 여러분이Motorola Solutions MSC-122인증시험을 패스하도록 도울 것이며 여러분은 ITExamDump에서Motorola Solutions MSC-122덤프의 일부분의 문제와 답을 무료로 다운받으실 수 잇습니다. ITExamDump 선택함으로Motorola Solutions MSC-122인증시험통과는 물론ITExamDump 제공하는 일년무료 업데이트서비스를 제공받을 수 있으며 ITExamDump의 인증덤프로 시험에서 떨어졌다면 100% 덤프비용 전액환불을 약속 드립니다.
Motorola Solutions인증 MSC-122시험을 패스하는 지름길은ITExamDump에서 연구제작한 Motorola Solutions 인증MSC-122시험대비 덤프를 마련하여 충분한 시험준비를 하는것입니다. 덤프는 Motorola Solutions 인증MSC-122시험의 모든 범위가 포함되어 있어 시험적중율이 높습니다. Motorola Solutions 인증MSC-122시험패는 바로 눈앞에 있습니다. 링크를 클릭하시고ITExamDump의Motorola Solutions 인증MSC-122시험대비 덤프를 장바구니에 담고 결제마친후 덤프를 받아 공부하는것입니다.
ITExamDump에서 출시한 Motorola Solutions인증 MSC-122덤프는Motorola Solutions인증 MSC-122시험에 대비하여 IT전문가들이 제작한 최신버전 공부자료로서 시험패스율이 100%입니다.ITExamDump는 고품질 Motorola Solutions인증 MSC-122덤프를 가장 친근한 가격으로 미래의 IT전문가들께 제공해드립니다. ITExamDump의 소원대로 멋진 IT전문가도 거듭나세요.
ITExamDump의 Motorola Solutions인증 MSC-122시험덤프는 실제시험의 기출문제와 예상문제를 묶어둔 공부자료로서 시험문제커버율이 상당히 높습니다.IT업계에 계속 종사하려는 IT인사들은 부단히 유력한 자격증을 취득하고 자신의 자리를 보존해야 합니다. ITExamDump의 Motorola Solutions인증 MSC-122시험덤프로 어려운 Motorola Solutions인증 MSC-122시험을 쉽게 패스해보세요. IT자격증 취득이 여느때보다 여느일보다 쉬워져 자격증을 많이 따는 꿈을 실현해드립니다.
시험 번호/코드: MSC-122
시험 이름: Motorola Solutions (Deploy WLAN Solutions)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 113 문항
업데이트: 2014-04-16
MSC-122 덤프무료샘플다운로드하기: http://www.itexamdump.com/MSC-122.html
NO.1 Your customer has requested that you configure unique VLANs for voice, normal user data with
802.1X security, guest access, and management traffic. Which of the following VLAN modes can support
this request?
A. Native Mode
B. Access Mode
C. Trunk Mode
D. Aggregation Mode
E. Encapsulation Mode
Answer: C
Motorola Solutions pdf MSC-122 pdf MSC-122 MSC-122인증
NO.2 You have an access point that requires PoE connected to a switch with a 150 meter 10 BASE-T CAT 5
cable. During testing numerous problems with both data transmission and intermittent power occurs.
Which of the following is most likely the cause?
A. The cable should be CAT 6
B. There is a duplex mismatch
C. The cable should be 100 BASE-T
D. The cable is too long
Answer: D
Motorola Solutions MSC-122 dumps MSC-122 dumps
NO.3 If a Motorola access point induces a 50 mW RF signal onto a 3 dBi antenna, what will be the resulting
EIRP of the transmitted signal?
A. 0 dBm
B. 3 dBm
C. 20 dBm
D. 50 mW
E. 50 dBm
Answer: C
Motorola Solutions MSC-122 MSC-122 MSC-122
NO.4 Which of the following APs does not support adaptive mode?
A. AP7131
B. AP6532
C. AP650
D. AP6521
Answer: A
Motorola Solutions MSC-122 MSC-122 MSC-122
NO.5 You are deploying a new WLAN within the WiNG 5 architecture. Which of the following is the only
UNSUPPORTED Motorola access point/port?
A. AP-300
B. AP-650
C. AP-5131
D. AP-7131
Answer: C
Motorola Solutions MSC-122최신덤프 MSC-122인증 MSC-122 dump MSC-122자료
NO.6 You have just conducted a throughput test using iPerf on a WLAN that shows a PHY signaling rate of 54
Mbps, however the average throughput rate shown in iPerf is only 23.5 Mbps. What is the most likely
explanation for this condition?
A. This throughput speed is considered nominal.
B. This throughput rate could indicate a mismatch between Wi-Fi confidentiality algorithms.
C. This throughput rate indicates excessive user activity.
D. This throughput rate indicates excessive out-of-band interference such as nearby cell phone towers.
Answer: A
Motorola Solutions MSC-122 MSC-122 dumps MSC-122 dumps
NO.7 Which of the following statements regarding the configuration of Motorola RFS controllers is TRUE?
A. ADSP can be used to push CLI profiles to APs and controllers.
B. LANPlanner can be used to push CLI profiles to APs and controllers.
C. RFMS can be used to perform predictive site surveys using an RFS controller
D. WiNG 5 can be used to perform manual site surveys using an RFs controller
E. CLI can be used to perform both manual and predictive site surveys using an RFS controller.
Answer: A
Motorola Solutions시험문제 MSC-122 dump MSC-122 dump MSC-122 dumps MSC-122 dump MSC-122덤프
NO.8 You have configured a Motorola RFS controller using WiNG 5 and have attempted to adopt a group of
APs using L2 adoption but the adoption is not successful. You have confirmed the following:
-All of the APs have an Ethernet connection to the same LAN segment as the controller -Spanning Tree
Protocol (STP) has been disabled on the APs next hop switch port -Intermediate firewalls are not blocking
EtherType 0x8783
Given this scenario, which of the following is the most likely cause of the unsuccessful AP adoption?
A. DHCP option 192 has not been defined on the DHCP server
B. A local VLAN has been configured on both the controller and the APs
C. The APs GE ports have been configured for an S02.1q-tagged native VLAN
D. The APs GE ports have been configured for an 802.1q-untagged native VLAN
Answer: C
Motorola Solutions MSC-122인증 MSC-122 MSC-122
NO.9 You are deploying a new system and are creating the RF Domain(s). Which of the following options
would you use to group the APs into the same domain?
A. By VLAN, where all APs are on the same subnet.
B. By site, which can be a location where the group of installed APs can hear each other's beacons.
C. By name, so they can be easily sorted in the tree view of the controller.
D. By deployment phase, so configurations can be accidentally pushed to newly installed APs.
Answer: A
Motorola Solutions dumps MSC-122 MSC-122 MSC-122
NO.10 You are designing a WLAN that will support multiple BSS IDs. One of the characteristics you need to
take into consideration is that each BSS transmits a beacon every 100 ms. How many BSSs can be
enabled on the following Motorola access points under WiNG 5: AP7131, AP650, AP6532?
A. 2, one per radio
B. 1 per AP, it is shared between the radios to provide seamless roaming
C. 8, four per radio
D. 16, eight per radio
Answer: D
Motorola Solutions자격증 MSC-122자격증 MSC-122 dump MSC-122 MSC-122 MSC-122
NO.11 During a recent throughput analysis test of your 802.11g network, you discovered that performance is
poor in comparison to previous baselines. You discover that this is the result of 802.11b stations becoming
associated with your access point. What option could you implement to eliminate 802.lib clients from
attaching to your network?
A. Implement protection mechanisms
B. Make 24 mbps a required data rate
C. Implement RTS/CTS at the access point
D. Change the channel used for the network
Answer: B
Motorola Solutions dump MSC-122 MSC-122 MSC-122기출문제 MSC-122
NO.12 Your customer has requested that during the upcoming 802.llg to 802.11n upgrade deployment you
enable 40 MHz channels on 1, 6, and 11 of the 2.4 GHz ISM band. You respond by saying that there is not
enough spectrum to allow 40 MHz channels centered on 1, 6, and 11. How wide are standard 802.11g
(OFDM) channels?
A. 20 MHz
B. 83.5 MHz
C. 5 MHz
D. 11 MHz
E. 22 MHz
Answer: A
Motorola Solutions pdf MSC-122자료 MSC-122기출문제
NO.13 Which of the following statements is NOT considered to be a best practice with respect to the wired
backbone serving the WLAN.?
A. When performing manual configuration of a point-to-point Ethernet link, ensure that both the speed and
the duplex mode settings on the two ports match.
B. When creating a link between Ethernet 10/100BASE-T or 10/100/1000BASE-T ports, enable (or accept
the default of) auto-negotiation on both ports.
C. When creating a link between Gigabit Ethernet fiber ports, enable (or accept the default of)
auto-negotiation.
D. When creating a link between Gigabit Ethernet fiber ports, disable auto-negotiation on both ports.
Answer: D
Motorola Solutions MSC-122 MSC-122 MSC-122 dumps
NO.14 Which of the following is the primary method of collision avoidance in an 802.11 CSMA/CA WLAN?
A. Backoff Timer
B. Carrier Sense
C. Contention Window
D. Enhanced Distributed Channel Access (EDCA)
E. Distributed Coordination Function Interframe Spaces (DIFS)
Answer: B
Motorola Solutions MSC-122 MSC-122자격증 MSC-122
NO.15 You are performing a physical site survey of a new WiNG 5 WLAN deployment. Which of the following is
CORRECT?
A. The Signal to Noise Ratio (SNR) is a critical measurement that needs to be addressed.
B. It is acceptable that you use any RF infrastructure device (Access Point) to perform the site survey test.
C. Using default settings of a site survey application will provide an adequate site survey result.
D. Customer throughput requirements are the only criteria for which need to be surveyed.
Answer: B
Motorola Solutions자료 MSC-122 MSC-122 MSC-122자격증 MSC-122 MSC-122최신덤프
ITexamdump의 000-955덤프의 VCE테스트프로그램과 70-561덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 000-N38시험에 대비한 고품질 덤프와 HP0-J67시험 최신버전덤프를 제공해드립니다. 최고품질 JK0-U21시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기